|
The component tubular heaters depending on the mounting provisions and configurations are suitable for use in solids, liquids, air as well as gases. These heaters provide the most design versatility of any electric heater construction. Tubular heaters because of their compacted MgO insulation construction can reach fairly high sheath temperatures, however the successful application of these heaters is primarily dependent on the end use.
A major advantage of Tubular heaters is the ability to form into custom shapes. Bend in radius as small as ½ the tube diameter depending on the tube material, configuration and application.
Solids heating can be accomplished by clamping of Tubular heaters to the heated object surface. Good surface contact is required in order to prevent localized overheating. Due to round cross section of the heater, it is always advisable to put a groove into the solid and the heater is pressed into the groove. Heaters can be configured with a flat surface pressed into the heater surface certain shapes limitations are applicable.
Tubular heaters are often cast into Aluminum for broad surface coverage and uniform heating application requirements.
Liquid heating requires the use of leak tight mountings/fittings provisions for direct immersion. Threaded mounting fittings, flanges, brackets and custom mounting attachments are used for this purpose and often include custom element shapes..
No two systems are alike It is extremely important that attention has been given to the total product or system design as well as operating environment.
|
